Featured products
-
IceCap Maxpect Gyre Interface Module - 1KHook up your Maxspect Gyre XF-130 or XF-150 pump to most 3rd party controllers using an available 0-10 volt port. -
Neptune Systems Automatic Top-Off Kit v2- Complete solution for replacing water lost to evaporation
- Super-simple to install
- Easy to use
- Three layers of redundant monitoring and water-level control
-
Neptune Systems ApexEL Entry Level System- Makes keeping your aquarium easier
- Lower cost version of the Apex
- Monitoring your equipment
- Easy to use
- IceCap Maxpect Gyre Interface Module - 3KHook up your Maxspect Gyre XF-130 or XF-150 pump to most 3rd party controllers using an available 0-10 volt port.
-
Neptune Systems Utility pump v2- 24VDC submersible pump
- Plugs in to the WAV Powerheads or Apex
- Can be used for ATO
- Improved version
-
Neptune Systems DOS + DDR Combo Pack- Combo Pack containing DOS & DDR
- Can be connected to an Apex
- Can be integrated into your other devices
- Easy to use
-
Neptune Systems Flow Sensor 2 "- Flow-sensor 2"
- Suitable for pipe diameters 32mm, 40mm and 50mm
- Used with a return pump
- Internal diameter: 43mm
-
Neptune Systems Solenoid valve- Solenoid Valve 24VDC powered
- Suitable for 4mm tubes
- Fits the accessory ports on FMM, 1Link & Energy Bar products
- 24VDC power supply not included
-
Neptune Systems Trident - Marine Aquarium Water Analyzer- Automatically tests Alkalinity, Calcium and Magnesium
- Communicates with your Apex
- Incredible precise
- Easy to use
-
Neptune Systems DOS + DDR Combo Pakket
-
Apex Kit Lab GradeStarterskit with: Apex unit, Energy Bar 6, Display module, temperature probe and ph probe (lab grade). -
Neptune Systems Apex Display ModuleSeperate display module that can be connected to an APEX computer. -
Neptune Systems WAV Starterkit2 WAV streaming pumps, a 1LINK module and a power supply. Suitable for Neptune Systems APEX Aquacontroller. -
-
-
Neptune Systems PAR Monitoring KitMonitor the light intensity of your aquarium with this PAR meter, including 'Real Reef Rock' -
Neptune Systems DOS Dual ReservoirDouble reservoice with big capacity (2x 2 liter) including sensors for the detection of low levels of fluids. -
Neptune Systems Spare DOS headSeperate DOS head for the replacement of a defective of worn DOS head. Lifetime of about 700 pump-hours. -
Neptune Systems Energy Bar 6 - EB6Smart power strip with 6 sockets, versatile programmable / switchable and including energy metering! -
Neptune Systems Vortech Pump Controller - WXMThis module can connect your Vortech pumps to your Apex computer. Making your pump(s) completely controllable and programmable. -
Neptune Systems ph/ORP/Redox probe Module - PM1Probe module for use with a pH or ORP/Redox probe. Also suitable to an I/O breakout box. -
Neptune Systems Salinity Module - PM2Probe module for use with a salinity / conductivity / salt probe. Has also a port for an I/O breakout box and a port for a temperature probe. -
Neptune Systems Advanced Leak Detection Sensor - ALD-P2Leak detection sensor to be used in conjunction with the ALD module. -
Neptune Systems Magnetic Probe RackThis probe rack has a strong magnet and is made of durable plastic. Suitable for 4 probes max. -
Neptune Systems I/O Breakout BoxBreakut box with 6 channels suitable for floaters, switches, leak detectors, push buttons and more. -
Neptune Systems Conductivity Probe Lab GradeConductivity probe for monitoring the salt / salinity in the water. -
ph Probe StandardpH probe to be connected with the PM1 module. -
Neptune Systems Temperature ProbeTemperature probe to be used with your APEX computer, a PM1 module or for use with the PM2 and PM3 modules for temperature compensation. -
Neptune Systems 2 Channel Light Dimming CableCable to connect 0-10V dimmable LED lights to a VDM module. -
Neptune Systems Aquabus cable M/M 183 cmLong Aquabus cable of 1.8 meters long. Use this cable to connect modules to each other. -
Neptune Systems 4 Meter Tubing DOSExtra tubing (4 meter) for use with the DOS dosing system. 4mm inner diameter and 6mm outer diameter. -
Neptune Systems 16 Meter Tubing DOSExtra tubing (16 meter) for use with the DOS dosing system. 4mm inner diameter and 6mm outer diameter. -
Neptune Systems 4.00 pH Calibration Fluid4.00 pH calibration fluid for use with pH probes of Neptune Systems. -
Neptune Systems 7.00 pH Calibration FluidFluid7.00 pH calibration fluid for use with pH probes of Neptune Systems. -
Neptune Systems Conductivity 447 Calibration FluidCalibration fluid for use with the conductivity probe and PM2 for Ro/Di (osmose) water monitoring. -
Neptune Systems Conductivity 53ms Calibration FluidCalibration fluid for use with the conductivity probe and PM2 for salt water monitoring. -
Neptune Systems 10.00 pH Calibration Fluid10.00 pH calibration fluid for use with pH probes of Neptune Systems. -
IceCap Alternate Gyre Mode Modified CableThis 6.5ft cable allows you to run your Maxspect Gyre in both forward and reverse direction by using one full Variable Speed port on your Apex to connect two 0-10v signals to a single IceCap Gyre Interface Module. - IceCap Maxpect Gyre Interface Module - XF150Hook up your Maxspect Gyre XF-130 or XF-150 pump to most 3rd party controllers using an available 0-10 volt port.
-
Neptune Systems UK plug converter for EB6- UK Plug converter
- Can be plugged into the EB6
- Very compact
- Apex ready
-
Neptune Store skimmer sensor- Sensor for Skimmer
- Measures volume of reservoir
- Can be connected to break-out box
- Length of floating rod is 8cm
-
Neptune Systems Apex 2016 Grade Lab Kit- Starterset with the Apex 2016 unit
- EB6 Powerstrip
- Temperature, pH, ORP, and Salinity probes
- Redox and salt electrodes
-
Utility pump v1Pomp geschikt om bijvoorbeeld osmose water op te pompen -
-
Neptune Systems Aquabus cable M/M 30 cmAquabus cable of 0.3 meters long. Use this cable to connect modules to each other. - Neptune Systems DOS + DDR Combo Pack
- Combo Pack containing DOS & DDR
- Can be connected to an Apex
- Can be integrated into your other devices
- Easy to use
-
Neptune Systems pH Electrode - Double Junction- Extra sustainable and accurate pH electrode
- Replacement for worn out probe
- Exta probe for another tank
- Probe for Apex Lite system
-
Neptune Systems ORP / Redox Electrode - Double Junction- Redox probe
- Monitor ORP in your aquarium
- Replacement for worn out ORP probe
- Lab graded probes tend to last longer
-
-
Backup BatteryHook up your 12v aquarium pump to the IceCap Battery Backup for continuous operation up to 35 hours after the loss of power. -
Automatic Top-Off Kit v1Veilige en complete kit met optische sensoren, pomp en magneetmontage voor het bijvullen van water. -
Neptune Systems Fluid Monitoring Module- Multi-purpose module
- Can detect leaks and water levels with the help of various accessories
- Powers various Neptune Systems accessories
-
Neptune Systems Flow Sensor 1 "- Flow-sensor 1"
- Suitable for pipe diameters 25mm and 32mm
- Used with a return pump
- Internal diameter: 20mm
-
Neptune Systems Flow Sensor 1/4 "push-fit connectors- Flow-sensor 1/4"
- Suitable for tubes of 4mm
- Used with aquarium accessories
- Internal diameter: 7mm
-
Neptune Systems Optical Level Sensor- Optical watersensor
- Suitable for the FMM module
- Signals your Apex
- Can be used for constructing your own ATO
-
Neptune Systems Optical Sensor with Magnetic Support- Optical watersensor with magnet
- Suitable for the FMM module
- Signals your Apex
- Can be used for constructing your own ATO
-
Neptune Systems Power adapter - 36W - EU / UK plug- 24VDC, 36W power supply
- Suitable for FMM and DOS modules
- 220 - 240 Volt
- EU / UK plug
- Neptune Systems Solenoid valve
- Solenoid Valve 24VDC powered
- Suitable for 4mm tubes
- Fits the accessory ports on FMM, 1Link & Energy Bar products
- 24VDC power supply not included
-
Neptune Systems Advanced Sensor Module - ASM- Allows sensors to connect to Apex
- Logs data of all sensors
- Works with 3rd-party sensors as well
-
Neptune Systems COR-20 Pump- An intelligent return pump
- No Apex System necessary
- Provides enough flow for 180 gallons aquariums
- With IQ-level feature
- Neptune Systems Trident - Marine Aquarium Water Analyzer
- Automatically tests Alkalinity, Calcium and Magnesium
- Communicates with your Apex
- Incredible precise
- Easy to use
- Neptune Systems Automatic Top-Off Kit v2
- Complete solution for replacing water lost to evaporation
- Super-simple to install
- Easy to use
- Three layers of redundant monitoring and water-level control
-
Backup Battery V2Hook up your 24v aquarium pump to the IceCap Battery Backup for continuous operation up to 35 hours after the loss of power.
-
Neptune Systems Trident 2 month reagent kit- Two bottles of Reagent A (changed every month)
- One bottle of Reagent B (changed every two months)
- One bottle of Reagent C (changed every two months)
- One bottle of calibration seawater sample